Decided to try my hand at (cheap) 3d modeling...
Posted: 2022-05-18 10:39pm
in Tinkercad!
My attempt to 3d model (for printing) a Transformer part. Specifically, the Trailer/Battlestation for G2 character 'Obliterator Pyro'
I might make it wider to get the big missile launcher cannon in when it folds up (it's just a little to small right now)
Weapons are from free set on Cults3d found at
https://cults3d.com/en/3d-model/various/pyro-set
(by MrUniqz)
My attempt to 3d model (for printing) a Transformer part. Specifically, the Trailer/Battlestation for G2 character 'Obliterator Pyro'
I might make it wider to get the big missile launcher cannon in when it folds up (it's just a little to small right now)
Weapons are from free set on Cults3d found at
https://cults3d.com/en/3d-model/various/pyro-set
(by MrUniqz)