Page 1 of 1
My Lightsaber design
Posted: 2005-07-26 12:45pm
by Lord Revan
With Dollar note and 2 € coin for scale
EDIT:
from another angle
Me holding the hilt (sorry no blade).
Posted: 2005-07-26 12:48pm
by Crazedwraith
Is it just me or does it look slightly wonky?
Pretty nice. I'm assuming this is only a basic repreentation and a final version would be a lot mre refined?
Posted: 2005-07-26 12:57pm
by Lord Revan
Crazedwraith wrote:Is it just me or does it look slightly wonky?
Pretty nice. I'm assuming this is only a basic repreentation and a final version would be a lot mre refined?
well I'm not sure if I'm gonna refine it anymore (and BTW it didn't cost a thing)
Posted: 2005-07-26 10:59pm
by The Jazz Intern
and they said mine was cheap ...
Really though, It's nice.
Posted: 2005-07-26 11:44pm
by DPDarkPrimus
What's with electrical tape on everyone's lightsaber?
Posted: 2005-07-26 11:53pm
by Spanky The Dolphin
Well, you get what you pay for.
Posted: 2005-07-27 01:40am
by Jason von Evil
The hell is a Fin doing with American money?\
OMFG FINNISH TERRORIST CELL IN AMERICA!!!!!!!
Posted: 2005-07-27 12:04pm
by Lord Revan
Jason von Evil wrote:The hell is a Fin doing with American money?\
left overs from a visit to the states.
Posted: 2005-07-27 12:14pm
by Dooey Jo
That's pretty good! Looks a little like the prop a friend of mine did. Has about the same amount of tape too
Of course, we put a fricking electrical switch for cars on it. That looked... interesting...
May I recommend glue, instead of tape? It looks better, and if you use a good two-component epoxy glue it should even hold together better. Or better yet, try to find some of that cement-like stuff they sometimes use for repairing details on cars. I managed to put a 12V recharge port on one of my lightsabres with that shit once. Not that it's connected to anything, but at least it looks cool...
Posted: 2005-07-27 12:16pm
by Lord Revan
Problem with glue is that I'm not sure it will stick to Aluminium.
