Burner isn't working

Lt. Dan · Post by **Lt. Dan** » 2005-02-17 07:46pm

Hey, my burner isn't working, could someone tell me if they've run into a problem? I use Nero and it says that there was a problem calibrating the power or something like that. This only happend within the last week. Help please.

General Zod · Post by **General Zod** » 2005-02-17 07:58pm

try checking the cables in the case to make sure everything's connected, maybe? if you've done anything to the innards lately that might've affected it.

Lt. Dan · Post by **Lt. Dan** » 2005-02-18 12:24am

Darth_Zod wrote:try checking the cables in the case to make sure everything's connected, maybe? if you've done anything to the innards lately that might've affected it.

I haven't touched the inside in a while and it worked not more than a week ago.

Vohu Manah · Post by **Vohu Manah** » 2005-02-18 01:09am

It wouldn't hurt to check. Besides, the problem could simply be the cable has gone bad (and replacing that would be cheaper than a new burner).

I had a similar issue with my DVD burner recently. The cable turned out fine and all it cost me to fix the drive was about twenty minutes, a screwdriver, and a can of compressed air.