How? The Iraqis are fighting a DEFENSIVE war, here, remember? There are only two ways to use such a tactic.Akm72 wrote:I agree that most of the Coalitions weapons are inappropriate in there initial state. But it is well within their capability to dig large exposive mines under the ground, and try to tempt the AT-ATs to walk over them before they remote detonate the mines.
1. Get the Iraqis to attack Saudi Arabia in force well after the Americans arrive. This is unlikely, as a force of Iraqis with AT-AT's would have attacked long before then, possibly without even waiting for them to show up. This would also require that the Coalition knew WHERE the Iraqis would attack. This is highly unlikely, as months after the arrival of Coalition forces they were still caught off-guard by the only, limited, Iraqi offensive into Saudi Arabia.
2. Get around the Iraqis and then force them to move back into mainland Iraq, after mining the highways and other thoroughfares.
The second is the easier method, by far, but it still has problems associated with it. First, it assumes that the walkers are not protected by smaller tanks, screening them. These tanks would likely explode and alert everyone to the Coalition's trickery. It also assumes the ability of the Coalition to move completely around the Iraqi flank AND physically occupy the main highways before the Iraqis can respond. This did not even happen in the real war, and it would be even more difficult against a group of Iraqis equipped with AT-AT walkers. BTW, you are assuming that walkers cannot detect mines, when their sensor and communications packages are known to be quite good--in fact, you are assuming that they cannot detect the presence of very large amounts of explosives under an area of earth that is likely quite badly disrupted by digging. You are also assuming that the Coalition would have had time to employ this. Thus, while more possible than the first option for the employment of explosives, it is also inadequate to knock out a number of AT-ATs.